GMA Pallet Coasters and Hand Truck
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Wood PLA smells amazing while printing.
- Rating
- 4.333 / 5
- Likes
- 484
- Downloads
- 1,102
- Makes
- 4
- Views
- 5,170
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I had seen a set of pallet coasters but wasn't quite happy with the model, so I fired up Fusion and recreated to spec a GMA pallet, then scaled it to about 1:11th (3.5:40). Found it would actually slice quite nicely at 0.20mm height, so I roughed out a hand truck to hold 'em and sent it. It's adorable 😄
Print two of the load wheels, one of everything else, and as many coasters as you'd like (four fit nicely on a 250x250 bed). I printed the coasters face-down and did a little manual support painting down the middle of the runners so as to only add a little time and material and still get a clean result. The Truck body requires a little support for it's butt. Print the wheels on their sides and add a little support under the block for the steering wheel.
Glue the bits to the truck and you're done!
Tuned print profiles available over on Makerworld.