Protectors for Coronet Hawk 1 1/4" and 5/8" Spur/Drive Centers for woodturning lathes
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Protectors for two selected types of the Record Power Coronet Hawk drive centers (spurs) for woodturning lathes.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 20
- Makes
- 0
- Views
- 143
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Standard Digital File License
Protectors for selected spur drives as used woodturning lathes
A good spur drive is sharp. It may cut your hand when 'popped' into the taper. Then you kick it out of the taper, it may cut your hand or get damaged when it falls on the ground. I got tired of looking around for a cloth (or a bandage) and made a few protectors. They also allow me to carry them around more easily when I am on tour.


This input file gives a model for protectors for two of my spurs:
- 1 ¼" Record Power Coronet Hawk 6-prong
- 5/8" Record Power Coronet Hawk multi-tooth
I printed on the MK4 in Fiberlogy FiberFlex 40D on satin sheet. I used the standard slicer settings. Both models have a flat surface I could use for support, so I could leave ‘teeth’ free, not biting the print. I printed the supporting area with 100% infill to ensure stiffness, so the point of the spur does not come through the base when pressed.
The designs have cuts in the sides to facilitate putting the protectors on, and, more important, taking them off the spur. The photo image shows a prototype of the 1.5" spur protector without such slots. It proved difficult to take the protector off, up to the risk of pulling the spur from the taper. I made some knife-cuts in the side and now I can take the protector off with a light ‘peeling’ motion. This did it for me so I did not print another, but changed the design. Having learned the lesson, I printed the 5/8" design with these cuts from the outset.