pump foiling wing (vase mode)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Hydrofil wing designed to be printed wtith vase mode
- Rating
- 0 / 5
- Likes
- 21
- Downloads
- 187
- Makes
- 0
- Views
- 1,343
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial
This wing is designed to be printed in vase mode with integrated support. This saves both time printing and weight of the wing.
The tip of the wing (the top part) might need to be filled and or sculpted since it won't be water/epoxy tight, if yoy plan on doing a vacuum layup. You can also decrease the layer height the last 10mm to get higher quality.
The wing is based on axis1010 (1500cm^2). Uses a NACA 4412 profile.
The whole thing should be around 300g (0.675mm linewidth). Print with regular vase mode settings.
The centerpiece should not be printed with vase mode.
For instructions check out my other hydrofoil design.
