Water distributor for printers with a small build volume
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The model can be placed on a 10-cup beer pong formation to fill all cups with approximately the same amount of water.
- Rating
- 5 / 5
- Likes
- 24
- Downloads
- 214
- Makes
- 1
- Views
- 1,089
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Share Alike
The model can be placed on a beer pong formation with 10 cups to fill all cups simultaneously with approximately the same amount of water. For reasons of hygiene, beer should not be used and the filled cups should not be drunk from. You can hold a 1 litre water bottle upside down slightly above the funnels. The water can then still flow out. The model requires a support structure. The model can be printed using a standard 3D printer build space. The contact surfaces of the arms must then be wetted with glue and attached to the model using the snap mechanisms. Positioning is done using the snap hooks and the serrated contact surface. The glue is mainly used to insulate and seal the channels.