Quick and Simple Easter Egg Dipper
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Only 1.5g of filament, prints in 5 minutes, shape with a heat gun
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 39
- Makes
- 0
- Views
- 165
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Spring & Easter
- License
- Creative Commons — Public Domain
In a hurry and need extra egg dippers for dying Easter eggs? Look no further!
These dippers use less than 1.5g of filament, print flat on the build plate in 5 minutes, and then get shaped afterwards by a quick bit of heat on the cutouts and a couple bends. I used a chef's torch to briefly heat the PLA before shaping, but a heat gun or even hair dryer should also work.
Print Instructions: I used 3 perimeters and 15% grid infill to ensure the dipper has enough strength to hold large eggs even after bending.
Tip: To keep the dipper from melting or distorting too much, use less heat than you think before trying to bend the dipper handle. Once the handle is bent, a little cold running water can help to immediately solidify the PLA and lock in the shape.