1 / 3
Eesythreed x1 spool holder 500g (for right side)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Spool holder i remixed so i could fix an extra spool of filament on my printer
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 21
- Makes
- 0
- Views
- 220
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
If you print this and put it together, it may come out very weak. I sanded the tabs down a bit until they could fit if you applied pressure. Then I superglued them together, when its dried i take a bit of the filament. Put is in the gap, put parchment paper over it(make sure it stays in place) and iron it so it welds them together. Do this on both sides and its done!
Use zipties to fasten them onto the rails of the printer.(back rails)