Rear Mount for Prusa XL Filament Sensor - Remix
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a remix of the model from kez for smaller nuts.
- Rating
- 5 / 5
- Likes
- 51
- Downloads
- 156
- Makes
- 6
- Views
- 1,331
- Reviews
- 5
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Public Domain
When trying to use the original model from kez I faced the problem that my M3 nuts where to small for the internal openings. This caused them to spin, when I tried to tighten the screws. I created this remix with tighter tolerances to fix this issue.
This model has openings with a side to side distance of 5,6 mm while the original model was 6.2 mm. I used M3 nuts with a width of 5,4 mm, which result in a nice snug fit.
The original model contains a great explanation on how to mount this, please check on that for detailed instructions.
I routed the bowden tubes in reverse order through the filament sensor (extruders to the top), which seem to work just as fine as using them in the intended direction.
| This model is part of my Prusa XL Drybox project. |