Wyze Doorbell Pro 45° camera mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
45° mount for a Wyze Doorbell pro camera.
- Rating
- 0 / 5
- Likes
- 12
- Downloads
- 73
- Makes
- 0
- Views
- 287
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
I could not find a decent 45 degree mount for the Wyze Doorbell Pro model. The one I did find had a 5mm gap between the mount and the doorbell. So I created my own. This version has near-zero gap between the doorbell backplate and the wall mount. It is also fully reversible so it can point 45° left, or 45° right.
I created this in Ondsel ES (Freecad).
Printed Settings:
Material: Generic PLA
Layer: .24
Walls: 8 loops.
Infill: 10% gyroid
Top/Bottom: 8 layers
Arachne engine.
I just installed this 2024-4-6 so I cannot yet verify that it will hold up throught a minnesota year. But my other PLA prints have survived well enough.