Wago 221-2411 Connector for 2/4/6/8
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A Remix of Jemand/Joschas Wago connector
- Rating
- 5 / 5
- Likes
- 26
- Downloads
- 208
- Makes
- 1
- Views
- 734
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
Hi,
a friend was in need to connect some wires for a project of his. I found the model of ‘Jemand/Joschas’ and it fitted his needs. We just needed a version for 6 wago 221-2411 clips in one piece and a base size of 52 mm x 39 mm for glueing it down. So I made this remix.
It works well in his project. I than added versions for 2/4/6/8 clips to this model to give it more usecases. There are versions with/without flaps and screw holes (3,30 mm).
I printed a few in PLA+ as also in PETG. The fit is good, no problems so far. Nothing special for the print parameters. Mine were:
- layer height: 0,3 mm
- walls: 2
- infill: 15% cubic
- 3 TOP & 3 BOT layers
The holes are designed as 3,30 mm, on my prints they turned out slightly smaller than 3 mm.
So depending on your printer calibration & the screws you wanna use you have to drill them a bit up.
Happy printing!