Řehtačka / Easter ratchet (one-piece)
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€4.52 – €5.52 net (excluding VAT)
For file: rehtacka_easter_ratchet_0.2mm_PLA_MK3S_5h23m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €5.02 excluding VAT (range midpoint).
- Weight reported by the author
- 55 g
- Print time reported by the author
- 5.39 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Nepotřebujete žádné lepidlo, pouze odstranit podpěry. You don't need any glue, just remove the supports.
- Rating
- 0 / 5
- Likes
- 12
- Downloads
- 101
- Makes
- 0
- Views
- 411
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Spring & Easter
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Díl rozložte na části a druhou část nastavte na 5 perimetrů a 100% výplň.
Zbylé obecné nastavení: 0,2mm výška vrstvy; 4 perimetry; 15% výplň; límec 10mm, odsazení límce 0mm.
Tisk se stromovými podpěrami, pouze je odstraňte a začistěte plochu nad nimi.
Odstraňte límec.
Lehce vezměte za ozubené kolečko a protočte jej.
Dále už by měla řehtačka fungovat.
Divide the part into sections and set the second section to 5 perimeters and 100% infill.
Remaining general settings: 0.2mm layer height; 4 perimeters; 15% infill; brim width 10mm and Brim separation gap 0mm.
Print with tree supports, just remove them and clean the surface above them.
Remove the collar.
Gently take hold of the gear wheel and rotate it.
Afterwards, the easter ratchet should be operational.