Magic Band Keychain
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€0.30 – €0.36 net (excluding VAT)
For file: PTW-106-1-PT-0689_Magic_Band_v2_Keychain_R4_10Sep2021_0.15mm_PETG_MK3S_26m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.33 excluding VAT (range midpoint).
- Weight reported by the author
- 2 g
- Print time reported by the author
- 26.4 min
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Turn your Magic Band v2 bracelet into a sturdy keychain. 1.) 3D print this keychain using PETG, 90%+ infill (solid),…
- Rating
- 0 / 5
- Likes
- 25
- Downloads
- 218
- Makes
- 1
- Views
- 1,428
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Fashion Accessories
- License
- Creative Commons — Attribution
Turn your Magic Band v2 bracelet into a sturdy keychain.
1.) 3D print this keychain using PETG, 90%+ infill (solid), <= 0.15mm layer height, and no supports. Orient the "face" of the keychain toward the bed, and the "back" upward. I used a textured heat bed sheet, which left a nice texture on the "face".
2.) Use a Phillips #000 ("triple zero", AKA very small) screwdriver to remove the two screws and backplate from the Magic Band v2 bracelet.
3.) Remove the RFID puck from the bracelet and put it into the 3D printed keychain.
4.) Attach the original backplate and screws to the 3D printed keychain.
NOTE: For me, the tiny screw holes in the printed part were open enough to get the screws in. If they aren't for you, perhaps heat a small pin or thin wire, and poke them open?
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
No
Supports:
No
0.15mm
Infill:
90%
Filament:
eSun PETG Semi-Transparent Purple
Category: Keychains