Solar Film Adapter for Canon SX60 HS
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A printed adapter for mounting a piece of solar film to Canon SX60 HS or similar camera.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 18
- Makes
- 0
- Views
- 140
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Physics & Astronomy
- License
- Creative Commons — Attribution — Noncommercial
Allows easy mounting of a 4" square piece of solar film to a Canon SX60 HS or similar camera.
Needed non-printed parts:
- 4 screws and nuts (I used 2x M3x8 and 2x M2x12)
- 4"x4" (101mm x101mm) solar film (I used this one)
- 3mm self-adhesive foam tabs for mounting (I cut pieces of out of this.)
Note: You can use the uploaded Fusion 360 model's parameter to adjust for different thickness foam.
Printing instructions:
Not much to say here, I use a 0.4mm nozzle with 0.2mm layer height. Most tolerances between parts were set at 0.2mm.
I'd recommend just printing a centimeter or so of the tube and testing that the diameter works with the particular foam pads that you have.
Assembly:
- Adhere the foam pads to the inside of the tube
- Note: I used only 3 smaller pads, but for light sealing, it would probably be better to have the full inner circumference covered
- Place the film in the FilmRetainer piece
- Carefully lower the Tube piece on top of it
- Use the two M3 screws to fasten it down on the corners where the FilmCover doesn't have tabs
- Place the FilmCover on over the FilmRetainer
- Use the two M2 screws to fasten the FilmCover
- Slide the TubeCap over the tube end
For use, I just unscrewed one of the M2 screws and let the FilmCover rotate out of the way.
I also uploaded a parametric model where you can adjust the gap between the camera and the tube. This should allow it to be used with different sized padding, or potentially even different cameras.