Blobfish DLG v0.1 - VERY EARLY RELEASE
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
More documentation coming soon.
- Rating
- 0 / 5
- Likes
- 38
- Downloads
- 265
- Makes
- 1
- Views
- 2,496
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
AUW: 45.5g
Battery: 150mah 1s
Servo: 2x 1.7g rotary servo
Receiver: RX42
Tailboom: 3mmx2mmx400mm carbon tube
Wing spars: 6x 1mmx400mm carbon rod
Instructions coming soon. It should be possible to reverse engineer from the photos if you're experienced. Nose cone should be printed vase mode with 0 top/bottom. Nose and wing panels are LW-PLA, Vase mode, 0 top, 2 bottom. Wing pieces are printed on the trailing edge on the bed. You'll have to trim out the sacrificial support areas with a sharp exacto blade. Cover with tissue paper of your choice, but be wary of warping as the trailing edge is quite thin.