1 / 3
Low Material Supportless Wall Hook
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A low material usage wall hook that can print without supports
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 17
- Makes
- 0
- Views
- 88
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution
This is a simple, single-screw wall hook that uses very little material. I originally designed this for hanging my pans on my wall, so durability was a must.
I printed these in both PLA and PETG, the PLA prints were surprisingly strong, but I would recommend using PETG if it's going to be hanging anything heavier.
Settings used:
- Black Prusament PETG
- 0.2mm Layer Height
- 0.45mm Perimeters
- 15% Grid Infill (infill isn't really that important for this print)
- 225°C Nozzle first layer, 250°C for other layers
- 90°C Bed for whole print
- 5mm/s First Layer