1 / 7
Ikea Lack Stack
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A 15 cm Ikea Lack leg extension for the top part to be able to stack them.
- Rating
- 0 / 5
- Likes
- 27
- Downloads
- 161
- Makes
- 0
- Views
- 1,605
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I designed two versions, the original is designed to be tightened with a screw from the inside to have seamless corners on the outside. The second (named “Mirror”) is the opposite, where the screw holes are on the outside. After designing it myself, I found out it was very similar to @Wossi1975_403070 design, but decided not to consider it as a remix. The screw holes are 4mm in diameter.
If you are interested in the Leg Risers for the bottom table, Click Here.
Print Settings:
- Filament: I recommend PETG, but PLA will be fine
- Layer Height: 0.3 - 0.35
- Perimeters: 3-5
- Top & Bottom Layers: 3
- Infill Pattern: Gyroid/Cubic
- Infill Density: At least 5%, I printed with 7%
- No supports needed