@Hangloose modified LMT-6 Connector
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a modified version of hangloose's connector. I modified it to a thru-box cable gland/connector.
- Rating
- 0 / 5
- Likes
- 12
- Downloads
- 98
- Makes
- 0
- Views
- 534
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
This is not my original. I couldn't upload it unless I selected it as such. Thank you @hangloose for letting me share this!
I use this connector to connect the 3 phase wires for a brushless motor. I used @hangloose's design and slightly modified the hole size for the bullet connectors because the ones he uses aren't available here in the US. I also made it to attach directly to my pelican case to replace the cable glands I previously used.
I use west system epoxy or thermal epoxy to seal the back of the connector and flex-it 70 two part silicone to pour the molds for the gaskets. Make sure to use some vaseline or similar on the molds or you will have to break the printed part to get the silicone gasket out. I use Fly RC 6mm bullet connectors that I buy on amazon. I print in PETG, 100% infill, 5 wall loops.
@hangloose's designs are really high quality and I would check his printable's page for an even better description and better pictures of the original LMT-6 connector and MT-60 connector and how he uses them.