3D Chameleon Y Pipe support Ankermake M5C
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Designed a Y pipe support for the 3D chameleon on an Ankermake M5C printer to stop it flailing everywhere.
- Rating
- 0 / 5
- Likes
- 22
- Downloads
- 42
- Makes
- 1
- Views
- 931
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
After Ankermake binned the V6 colour engine I was forced to look elsewhere for automated colour changing capabilities for my Ankermake M5c. The 3D Chameleon looked promising but the Y pipe was essentially not secured to anything and did a bit of ‘flailing’ when using the printer in fast mode, or even, normal mode. So I designed this to hold the Y pipe steady.
The model utilises void volumes so the model file picture below does not resemble the actual model. Please see photos.
0.2mm layer height is sufficient