Cup smartphone holder

I drive a VW bus sometimes and on the steering level there is a cup holder, so I decided that it would be a good place for a phone holder. After way too much time designing this I release it now to the public.

Everything except two m3 screws (6 to 8 mm) is printed. I printed it on the bambu p1s, so be mindful of the tolerances. You print two side brackets, resize them to get the proper rattle, not too tight and not too lose. The two holders go on the left and on the right side. Be careful with the supports on the holders, lay it flat on the flat part and the rest you should use with supports. Carefully pry it loose. 

The large base model should be printed from the round bottom, upwards, with a draft for extra stability.

The two brackets are a rudimentary spring so they push a little bit back agains the phone. If you want to use in in the summer…dont forget to remove it in full sunlight, or use a better material like ASA, because cars and plastic…well…melty tiem XD

Commercialization is mildly accepted but you would have to give me $$$$ too 😱😱😱