Fixture for Dremel Model 3000
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
When working on difficile parts with a Dremel it's a good idea to guide the part by hand rather than the machine.
- Rating
- 0 / 5
- Likes
- 25
- Downloads
- 111
- Makes
- 0
- Views
- 823
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
NOTE: This holder is designed for Dremel model 3000. It is a new model in addition to my earlier post for Dremel model 315!
When working on difficile parts with a Dremel grinder it is good idea to guide the part by hand rather than the machine.
Designed this fixture with TinkerCad.
Printed on my Prusa MK4 with Geeetech PLA (grey) with IS-structural settings:
4 perimeters, 4 top and 4 bottom layers. Used organic supports where necessary, those came off easily. Clamps printed lying on their sides for stability reasons.
Only rework I had was to clean the surfaces of the hinges (cutter and file), Center hinges ("upper clamps") received an introducing M3 thread from both sides, not too far → for self locking. With that said I only needed a M3 buttonhead screw and no nuts. Clamps fastened by selftapping screws (T10), directly screwed in. Hinges are locked by two rubber O-rings: ID18mm, t Ø3.5mm.
Logoplate is not a must. But can be printed on Prusa MK3/4 with MMU2s/3 Black = Prusament Galaxy Black PLA on textrued Prusa build plate. Glued on by Uhu. Adhesive Foam strips for the bottom part and for the clamps, for smoother fit.
If the print is nice without stringing or any other blops or impuritiesthen it should be assembled withing 3 minuted from taking off of the build plate.
NOTE: This is for DREMEL “Model 3000” which is a very common model. DREMEL “Model 315 does not fit in this fixture. Therefore, I designed a (first) model with some commonly used st-files.
Model 315: https://www.printables.com/de/model/840014-fixture-for-dremel-model-315-2002
Good luck with your fixture and Happy Printing!
Explore my other Printables: https://www.printables.com/de/@Tritschi