1 / 4
Foldable adjusting tablet stand/holder
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Modeled for iPad Air, but can be used for any other tablet with similar size.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 36
- Makes
- 0
- Views
- 405
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial
Holder/stand for iPad Air or any similar sized tablet. The holding area has 15,5cm x 15cm.
What will you need
- 4x M3x20 screws
- 4x M3 nuts
- Super glue
Print instructions
- Used material: PETG or PLA
- Layer height: 0.2mm
- No supports needed for all models
- For model ‘Top body’ use 30% infill, rest of the models can use ~20%
- Model ‘Tablet holder body’ must be printed twice
Assembly
- Part ‘Tablet holder body’ should be super glued to part ‘Top body’, put a little bit of super glue inside the hexagon hole and then insert the small parts
- Screw 4 places with M3x20 screws and M3 nuts, placeholder for a nut is on the inner side