Garbage and recycling bin clip for raccoon deterence
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Clips for the following Toronto refuse collection bins: 1. Small garbage bin (75 litres) 2. Large recyling (240 litres)
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 71
- Makes
- 0
- Views
- 379
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Public Domain
Raccoons can easily get into City of Toronto garbage and recycling bins and make a big mess.
Two-step clip removal: this design require the user to 1) press on the mid-clip section with the thumb while 2) that hand's fingers rotate the clip's bottom away from the bin's lower lip.
Note that there are a multitude of Toronto bin sizes. Further, different generations of a particular bin size have different lid types.
This design is for the following particular sizes and lid geometry:
Small garbage bin (75 litres) with dual square cutouts in the lid
Large recycling bin (240 litres) with dual round 5mm cutouts in the lid
Consider small scaling adjustments when slicing to allow for bin manufacturing variances and printing material shrinkage, e.g., the pictured garbage bin clip is printed in ASA at 99% of full size to get a snug installed fit.
Version 1 recycling clip (20240419): The recycling bin clip uses 2 M4x16mm countersink screws to mate with the bin lid cutouts. The design includes a cavity for optional m4 hex nuts to support the screws. This cavity is very tight to the nut.
Printed in PETG to a) provide sufficient flexibility and b) handle the heat of direct sun. PLA's “creep” property likely would not work in this application.
Clips are printed at 60% gyroid infill. Still to be determined is the effect of water ingress and the impact of freeze/thaw cycles – may need to go to 100% infill. [20251231: no issues noted after several months of sub-freezing temperature use, i.e, 100% infill does not appear to be required.]
Version 2 recycling clip (20251231): Eliminates the metal screws and instead uses integrated 3D printed posts to mate with the two bin lid cutouts. This version was printed in ASA with 20% infill. The photo shows the two plastic posts highlighted with red Sharpie.
