Coyote cannon torch 30mm scope mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Needed to mount this beast of a torch to my scope without having a big cantilevered stress on it so this is what I came
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 19
- Makes
- 0
- Views
- 195
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial
Needed to mount this beast of a torch to my scope without having a big cantilevered stress on it so this is what I came up with, mounts very firmly and doesn't slide around at all even when you bump the rifle, and it should be perfectly in line with the scope.
Requires a M6x60mm and M6x70mm bolt and nuts (or just two 70mm but the bolt will stick out a bit on the rear mount), insert a pause print on the layer for each mount where it closes up the slot for the nut and then insert the nut firmly, you may need to give in a little tap with something hard to get it seated flush.
Printed with 6 perimeters, 7 top and 6 bottom layers at 0.3mm layer height for optimal strength.