Guiro - the whole Percussion frog with support only in the mouth
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€5.50 – €6.72 net (excluding VAT)
For file: percussion frog complete_0.8n_0.3mm_PLA_MK4IS_3h12m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €6.11 excluding VAT (range midpoint).
- Weight reported by the author
- 137 g
- Print time reported by the author
- 3.21 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Guiro - percussion frog prints complete with the sticks.
- Rating
- 5 / 5
- Likes
- 43
- Downloads
- 454
- Makes
- 1
- Views
- 1,451
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Percussion Frog 90% infill, WITH SUPPORT, only in the mouth
In Prusa Slicer, you can now easily add support manually with the brush. But it's still not that easy. So here are my .3mf-files (for the MK4).
Two versions: Original size and 200 % size.
I recommend printing the 200 % frog (with 90Proz infill) with PLA. It is realy loud and sounds very good :-).
Tip: To remove the support, simply "press down hard on the teeth" with pliers or a fine knife, at the top and again at the bottom if necessary - on both sides of the mouth - then the support will pop out in one piece :-). Take courage :-).