Scalp Massager (Head Scratcher)
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.71 – €0.86 net (excluding VAT)
For file: head_scratcher_0.2mm_PLA_MK3SMMU2S_58m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.79 excluding VAT (range midpoint).
- Weight reported by the author
- 6 g
- Print time reported by the author
- 58.2 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A fantastic gadget to provide a gentle tingling sensation on your scalf.
- Rating
- 4.8 / 5
- Likes
- 95
- Downloads
- 683
- Makes
- 8
- Views
- 4,873
- Reviews
- 5
Updated at source:
Model information
- Source
- Printables
- Category
- Home Decor
- License
- Creative Commons — Public Domain
A scalp massager is a perfect quick print to show of your 3D printer. The core can be printed in less than 60 minutes, and during that time you can prepare the 16 individual wires from a 3D printing filament.
Printing instructions
Orientation: As shown in the rendering picture
Supports: Not needed
Layer height: 0,20 mm
Material: PLA, PETG
Infill: 0%
Raft: Not needed
Assembly instructions
- Print the provided model
- Cut 8 short & 8 long pieces of 3D printing filament
- Recommended short length: 12cm
- Recommended long length: 17cm
- PETG if preferred, but PLA will work too
- The filament has to be 1,75mm in diameter
- Make sure to cut the filament perpendicular to avoid the ends being sharp
- Assemble the shorter pieces to inner holes (8 pcs)
- Use pliers to push the filament into the holes. No glue needed.
- Be careful and push them straight into the holes, otherwise they might break.
- Assemble the longer pieces to outer holes (8 pcs)
- Adjust by bending the filaments as required
- Enjoy!