1 / 5
Lil Piglet Snout Stabilizer Remix for OEM Barrels — image 1
1 / 5

Lil Piglet Snout Stabilizer Remix for OEM Barrels

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

The Lil Piglet snout remixed to work with OEM barrels with the factory front sight installed

Rating
0 / 5
Likes
5
Downloads
82
Makes
0
Views
343
Reviews
0

Updated at source:

Model information

License
GNU General Public License v2.0

Note: This is not a gun part.  It is a support for a stock.

This is an attempt at a remix of the Danmilton's Snout support for the Lil Piglet.  The original is for a bigger target barrel with no front sight.  I wanted one to support the 10/22 OEM barrel.

I made the opening for the barrel in this mix a little smaller from the original while keeping the same outside dimensions.  This fits my barrel after some fitting.  You will probably need to do that at the top and bottom like in the picture.

I didn't want to remove the OEM front sight so this snout is split in two halves and added some pins so it doesn't need to fit over the end of the barrel with the sight installed.  The pin holes are 3.1mm and pins are 3mm - you might need to use a 3mm drill bit by hand in these holes and you might need to make them deeper on one side.  No glue needed since the stock holds it together when the screws are installed.

You will need supports for the two halves of the snout and probably a brim for the pins.  


NOTE: This may, over time, leave a mark on your barrel where it rubs on it.

I used black Overture ASA for the one on the photos. 

Thanks to Danmilton for the original.

 

Tags