A Phone Stand in 20 Minutes
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.27 – €0.33 net (excluding VAT)
For file: Smaller stand_0.3mm_PLA_MK3S_20m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.30 excluding VAT (range midpoint).
- Weight reported by the author
- 3 g
- Print time reported by the author
- 19.8 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A shorter version of my 47-minute phone stand. Most stable in landscape mode, but supports portrait too.
- Rating
- 4.76 / 5
- Likes
- 239
- Downloads
- 2,277
- Makes
- 32
- Views
- 5,549
- Reviews
- 25
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Creative Commons — Attribution — Share Alike
Hard to print? Try this one
This is another take on the idea of a quick-to-print phone stand to make lots of and put around the house. If you don't need your phone to be elevated and are looking for something that takes up less space, this is the model for you. Supports both portrait and landscape, but if you are using a taller phone in portrait you can knock it over pretty easily. In landscape, it is extremely stable though because the phone basically sits on the table. and the center of mass is very low