Modular Electronics Mount for Chopper (CH-10P)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Modular electronics mount for CHOPPER (C1-10P).
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 40
- Makes
- 0
- Views
- 291
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Based on and Remixed from the fantastic solution from Tim Hebel.
This version is designed to be a little easier to print and to customise based on the variety of possible components.
Print:
Recommended minimm of 3 walls (perimeters) with 10% infill.
Brim may assist with bed adhesion.
Assembly:
L1 and L2 attached with glue (2-part epoxy is recommended) and twp short pieces of 1.75mm filament for alingment. The same approach is used for attached R1 and R2.
The Toggle Switch face Plate is used to bridge the Left and Right portions. Use 4 x M3 bolts and nuts.
The entire frame mounts to your Chopper build with 7 x M3 bolts (M3 nuts should be installed in the rear body frame already).
Panels (P1 - P 11) can be printed as needed. Panels are attached to the frame with either M3 bolts and nuts or M3 Bolts and M3 heat inserts.
Panels are arranged L2, L1, R1, R2 from top to bottom (i.e. P2 would be the second slot on L2 frame or P6 would be first slot on the R1 frame).
Print as needed.
Panel Size: (HxW)
P1 - P3: 55mm x 80mm
P4 - P5: 55mm x 45mm
P6 - P8: 55mm x 35mm
P9 - P11: 55mm x 75mm
Electronics:
Electronic components can be attached to the panel by either bolt/nut, two way tape or hot glue.
Each panel has upper and lower cutouts to aid in cable management.