1 / 2
LEGO Technic Audi RS Q e-tron 42160 Wall Mount
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Vertical wall mount for the LEGO Technic Audi RS Q e-tron set number 42160
- Rating
- 5 / 5
- Likes
- 25
- Downloads
- 259
- Makes
- 1
- Views
- 1,306
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This model is designed to be printed as three separate parts and then snapped together.
- Print one plate and two arms, flat on the bed. The orientation should already be set.
- I recommend PETG, ABS, or ASA for best performance. In theory, PLA is more subject to creep over time from constant load bearing but it should work for all practical purposes. I err on the side of caution.
- I used the Prusa MK4 0.2 structural settings but set perimeters to 3 for a little extra strength and screw hole reinforcement.
- Connect the arms to the plate by hooking it over the top near the screw holes and then snap it down into place.
- It will require a bit of force to snap the arms in. This is ok!
- Hold against the wall and mark the desired hole locations (hold a bubble level against the bottom for best results).
- Drill holes as appropriate (for anchors or your desired method). I used standard wood screws and the design will accommodate various head types (countersunk, bugle, pan, etc).
- Mount against the wall using the left-hand screw first ensuring it is snug enough to allow rotation.
- While holding level, mount the right-hand screw and tighten it down.
- Tighten down the left-hand screw.
The model mounts into the chassis underside, just fore of hub, on both sides of it.
If you have interest in selling prints of this model (selling prints aka commercial use is NOT ALLOWED) please contact me for options before I find it on eBay and issue a takedown notice. Thank you.