Replacement Gasket and Cap for Shark S3501 Steam Pocket Mop water tank
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Gasket and Cap for Shark S35010 Pocket Steam Mop water tank Gasket - TPU; Cap - PETG, ASA, ABS, PLA+
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 152
- Makes
- 0
- Views
- 813
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Recently purchased an “Open Box” S3501 Shark Pocket Steam Mop. I had purchased at a steep discount from one of those sites that sells Amazon returns (Mac.bid) in April 2024. When I got it unpacked, noticed the cap (and gasket) for the water tank was missing.
I designed a replacement for both using Morphi software (a 3d design program no longer available). If anyone still uses Morphi and wants the original Morphi file to edit, please leave a reply and I will provide.
Suggested print settings:
I printed the cap itself on a Bambu X1C using PETG, and the gasket was printed on a i3 MK3S using Sainsmart 85 TPU. The pictures show the mop and cap sitting on my kitchen counter.
Strength (for the cap) - Use 6 walls or greater (I used 8 perimeters). This is required. I also used 40% infill. Need to have the best possible layer adhesion, since there will be some stress pulling on the layers as you tighten the cap
Fan settings - Low (30-40%) or off, again to promote better layer adhesion
Supports - Required for the cap. Print upside down (cap down, see pictures)
I used Organic (Tree) supports. From the “build plate only” on Bambu Slicer, but I had to turn this setting off on Prusa Slicer. I set the top z distance to zero, provided better support, but a little more difficult to remove the supports with clean separation. Not too big a deal, since this is not a sealing surface, and not usually visible.
Using these settings resulted in the best print quality, and easier to remove supports.