1 / 1
xTool S1 Honeycomb Brace
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I made this to help stabilize the honeycomb panel in an xTool S1 laser. It pushes the honeycomb to one side.
- Rating
- 5 / 5
- Likes
- 142
- Downloads
- 1,102
- Makes
- 10
- Views
- 4,157
- Reviews
- 10
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial
I originally printed this in PLA since it doesn't need to be super rigid, a little compliance is good. However I would recommend PETG if you can. After a few months, PLA will creep and doesn't bounce back as much.
Good amount of pressure applied w/ 3 wall loops & 0.4mm nozzle, could do 2 loops if it's a little too stiff.