SnapCase For Raspberry Pi4B
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Screwless Snap Assembly Designed to fit a Hat Board as well, it can be used to fit a fan...
- Rating
- 4.959 / 5
- Likes
- 713
- Downloads
- 3,437
- Makes
- 53
- Views
- 14,096
- Reviews
- 49
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Screwless Snap Assembly.
Start with base or bottom case, remove ssd and drop Pi4b board into bottom case so that it rests in provided IO openings correctly. Fit should keep board in place even with a little shake. Place Screwless Jack onto Pi 4B board matching posts with screw locations. Top will snap onto the base, holding the screwless jack onto the Pi 4B board and keep it in place.
There are 2 top versions, with options to different camera and display ribbon cable locations (hexcase4-top and top-hex-cam2.). Each top has relief and boss locations on the RJ45/USB ends, top parts are not flipable and must be assembled in the correct orientation. There should be an even part line between top and base.
To dissassemble the case, first remove the SSD card! You can use a hex wrench or paper clip/ finger nail to pry up the top near the USB/RJ45 IO area.
There are 4 screw boss located in the base if you want to use a hat board.
Pi takes M2.5 (a set of 4 screws and nuts needed... 4 standoffs and another set of 4 screws for Hat Boards) . The platform for the MLB is a snug fit, so it is possible to skip the screws).
Print instructions
Please NOTE! Remove the MicroSD Card before assembly and disassembly!
Print files are for ABS
No supports needed... io inserts will pop out...
Generally longer time for this case due to the increased surface area.