Playseat Challenge Heusinkveld V2 Handbrake Support
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A Heusinkveld V2 Handbrake Support for the Playseat Challenge chair that also somewhat supports the adapter plate
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 28
- Makes
- 0
- Views
- 670
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Video Games
- License
- Creative Commons — Public Domain
Heusinkveld V2 Handbrake support for the Playseat Challenge, following the long chain of remixes from jeoje's original design. This won't mount on its own, but rather requires this support system. The version I use, and I designed against, is Bald-har's design. This remix only changes the handbrake support to allow for mounting Heusinkveld's V2 Handbrake, in theory also keeping the previous M8 support (untested). For all the other print parts, refer to Bald-har's design.
This whole model had to be reversed from STLs, so chances are the measurements won't be a 100% match, but it's as close as I could get, and the holes match up fairly well. The f3d and step files should allow for easy editing if needed.
The support only supports the 0° orientation of the adapter plate. Other orientations are not supported and would require a not trivial redesign of the whole adapter. I might go back to this and add support to those, but even if not, since the CAD files are included, it should be feasible for someone else to add them if needed.
Assembly Instructions:
For attaching the support to the main part, you'll need at least 5 M3 screws and M3 washers and hex nuts. I used M3x25mm screws but you might be able to use M3x20mm as well (pays to buy at least 7 of each in case you ever want to change the orientation of the mount). For the Heusinkveld V2 Handbrake, you'll need either 4 M5 screws/washers/nuts, or 2 M6 screws/washers/nuts.
If you use the adapter plate, you'll first need to attach the handbrake to the adapter plate. For this you'll need 4 M5x10mm screws, as well as M5 washers and hex nuts. 4 of these with hexagon cap head are included with the handbrake. If attaching the handbrake to the support directly without the plate, you'll need at least 13mm screws (that's the height of the support base), but you might want more clearance due to handbrake + washer, so anything from 15-20mm should work.
If you use the adapter plate, you'll need 2 M6 screws/washers/nuts. M6x20mm is likely going to be the minimum, but anywhere from 25-30mm should be safe (it'll just stick out a little bit).
Print Settings
These are the options I used, but I'm still new to 3D printing so you might find better choices
Filament material: PETG
Rafts: No
Supports: Yes (I used them for the top tail holes and nuts, but you might be able to get away without)
Resolution: 0.3mm
Infill: Gyroid 70%
Perimeters: 4
Bottom Layers: 5
Top Layers: 5
All other options are the default from PrusaSlicer's Generic PETG profile.