Napkin holder

This is a simple design napkin holder in two sizes: 
   - Rectangular with an inner size of 100x195mm
   - Square with an inner size of 203x203mm

It has an indent on two sides. You may print it just as it is an leave these indents as they are. 
But you could also print the corresponding inlays and glue them with beveled side into the indent of napkin holder. This will create a nice shadow gab. Picture below shows how to glue the inlay it into place:

In title picture I have decorated the inlay parts and added a text. Then I printed them with the writing down to a textured print sheet using a multi material unit for color change. To hide print lines even more, I used an aesthetic infill: The Hilbert curve. Here you can see the first layer on textured print sheet: 

But you could also decorate these inlays with paint and glue them into place when done. Anyhow you should be able to get a nice individual napkin holder at the end.

Hope you have some joy in designing your own inlays for these napkin holders.

Some additional info about the title picture print:
It was printed with 0.4 standard nozzle on a Prusa MK4 and following print settings in PrusaSlicer:

Material: Prusament PLA Galaxy Black

Layer hight: 0.15 mm
Perimeters: 2 (to avoid warping and bending due to too much stress in material)
Infill density: 15%

For the square one, you may want to add little helper discs in corners to avoid lifting (warping).

Happy printing…