1 / 4
Dog Paw
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Dog Paw with hole for magnet. I printed 2 and put them on my screen door so my dog wouldn't run into it anymore.
- Rating
- 4.667 / 5
- Likes
- 38
- Downloads
- 594
- Makes
- 4
- Views
- 1,243
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Animals
- License
- Creative Commons — Attribution
Dog Paw with hole for magnet in the back. I printed 2 and put them on my screen door so my dog wouldn't run into it anymore.
Printed at 0.2mm layer height, 15% infill, I tried printing it with and without supports, both worked fine. Added a printer pause to switch filament to get the 2 different colors.
The magnet I used was 15 mm in diameter and 2.7 mm in height, it fit in the model snuggly but I did use some superglue to make sure it wouldn't fall out.