Tapping / drilling arms
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A freecad model & minor remix of Chris tapping arm.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 35
- Makes
- 0
- Views
- 443
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
These are illustration for the build.
The only downside of threaded stem, is that you have to cut them. For this I used a dremel with this setup + a nuts before the cut to redo the thread after.
To tight them, I am using 2 nuts: one that is static in the base, and a second to block rotation.
Using a handdrill, we can screw them through the whole structure, and then tight them back
As said, I made the model a bit taller, by printing an extension after having printed the parts at their original size
Adding the 20mm tube, That way it's easy to measure the exact length needed.
Detail on the inner filler,
For the table: I used a cheap Ikea kitchen board. And choose to have it in the upper left corner (as I am right handed). It's attached using a special foot that host the nuts.
