Simplified Petsfang Bowden Direct with BMG Hotend Mount (Printed without support)

This remix only works with v6 and BLT only. It does not work with EZABL. And I only have a Ender 3 Pro to test it on.

This is a remix of Petsfang Bowden Direct with Bondtech BMG hotend mount (works with v6 and BLT only) with the following modifications.

• No more broken pneumatic connectors! Eliminate the need of pneumatic connectors with a printed one to connect the BMG and v6
• The back is flat so that it can be printed with the back on bed
• The cable management and EZABL mount point is removed
• No support is needed to print

Because of the a printed connector is used, there is a v2 version but is not tested.

• Remove unnecessary part to support the BMG as it is now sufficiently supported by the printed connectors and the stepper motor plane
• I have to drill the holes on the mount to install. So this v2 has a bigger hole to avoid drilling
• Round some corners as there are minor warps at sharp corners on my print

The remix function of Thingiverse is not working and so I include the original link here. https://www.thingiverse.com/thing:2963434

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

0.12

Infill:

Filament: Polymaker Polylite PETG Polymaker Teal

Notes:

Category: 3D Printer Parts