Smoke sucking for LASER engraver
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I did not find any suitable smoke sucking for small LASER engraver. So I design one. It can be used also for soldering.
- Rating
- 0 / 5
- Likes
- 5
- Makes
- 0
- Views
- 585
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Commercial Use
You will need these thinks:
- Power cord for 230V
- Rubber band 4x
- Fan 120x120x38mm
- Air vent hose from NEDIS diameter 100mm
- Screw 4x
- Clip for 2 wires
- Printed Main body, Lit and 2 ends
Both air vent hoses does not need to have same size. I am using 1.5m and 3m. Go here for getting NEDIS hose. In Czech republic you can buy a hose here1.5m … 3m … 6m
The fan size should be 120x120x38mm. I have chosen fan with 23W - A2123-HBL (7) GN - available on Mouser or Conrad. In Czech republic you can buy it in GM here. Please note that fan fits into a sucker body only in one direction. It is slightly conical on one side - do not overlook it. You can buy another fan with lower voltage. I has been preferred 230V. 23W was the maximum available power for this fan size. Also fan with ball bearing has a little bit more effectivity.
Cable mounting is depicted at image. Please do several loops of wire to prevent cable to be pulled out. Power cable could be obtained or bought elsewhere.
Please insert a hose into a hole first. Then use a rubber band as depicted on image. I have used differend rubber band color to be visible.
Sucker main body needs supports. I have used a setup depicted in sample files. It is better to use 0.6mm nozzle, you will save time, but you will need more fillaments. 2 perimeters and 15% infill on 0.4mm nozzle seems to create sufficiently robust box.
Sucker lit does not need supports at all. Sucker hose cover needs tight supports in 4 small areas. There are two versions of hose end provided. Second version has small horizontal legs.
Note: Analogic commercial produkt looks much more humble.
Update: Sucker lit with switch is available. Please print eithed “sucker lit” or “sucker lit switch”.
Update 2: Just for the case, when you feel 23W fan sucking power to be too weak, it is also published adapter for DFA200 (CZ) fan with 128W and 800m^3/h.