TENT PEG GROUNDSHEET SAFETY DISK
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Never lose a tent peg or trip over a ground sheet corner peg again!
- Rating
- 5 / 5
- Likes
- 367
- Downloads
- 638
- Makes
- 4
- Views
- 4,950
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
If you haven't lost a tent peg or tripped over a peg slightly above the surface of the ground, or the edge of a ground sheet, you have no use for this model!
If you have, read on.
EASE OF USE
Simply hammer in the pegs as you usually would. Just don't go nuts hammering on the print, it WILL break!
SAVES TEARS
There are the kind of tears you shed when your groundsheet tears (rips) - if you don't have an edged groundsheet, the disks will help spread the load if you peg though it, avoiding unnecessary fraying.
HOT TIP
I use shorter pegs (100mm) to deal with the hard ground we have here in Australia, and sharpen them to a point to make hammering them much easier
REMOVAL
If the peg is a bit stuck, don't lever it out, simply rotate the disk a couple of times to break the friction and they'll just pop out.
STACKABLE
The do disks take up space, but they click together to keep them tidy
EASY PRINT
I've used PLA, you can use anything you like! 0,2mm layer heights will give a nice finish, the rest is up to you.