tinySA Ultra desktop stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A stand for the tinySA Ultra
- Rating
- 0 / 5
- Likes
- 13
- Downloads
- 147
- Makes
- 0
- Views
- 995
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The tinySA Ultra neatly pops onto this stand, held in place by small lugs that fit into the screw holes on the back of the device. It leaves all the controls accessible and has enough clearance for a small USB C cable at the bottom.
Make sure the lugs are not too tight so they don't get stuck in the device. I didn't need to, but you may need to sand them down slightly if they are a tight fit. The stand is hollow so doesn't use as much filament as it looks like. I printed in PLA+ at 15% infill with no supports and it turned out great.
There are two versions, one has a pocket for the stylus and the other does not.
If you also have a NanoVNA-H4, there is a matching stand for that device here.