Pedro Raccoon Windmill

Pedro - The Raccoon Windmill - Self adjusting wind turbine

Now it's spinning crazy! 😜 I see this trending sweet raccoon with the Pedro Song on Instagram and

after the great success of my other windmill designs, i decide to integrate the Raccoon.

• Ah crazy but really nice decoration for your garden or balcony.
• Self adjusting to wind direction through the Tail Blade
• 100% printed, no Screws or tools needed
• You can add 2 Propellers on one Axle with 2 distances
• Print Left & Right spinning directions to get nice effects
• Rods are stack able to your needed height

Printing:

The rod could be a bit difficult to print, i added custom support, but clean your buildplate and apply some glue.

Tested with PETG & PLA 👍 Prefer PETG for Axle and Rod

Pre-colored Orca Slicer Profile is added. 

Info:

The raccoon is slightly extruded. Simple colored it in slicer. 

I used Orca Slicer and added a 3mf file.

This time the Axle is a bit shorter to add only 2 propeller with 10mm and 2 distances with 5mm each.

I added another tail blade with some waves. My other propellers and tail-blades are still fully compatible if you want to mix it up:

• Toroidal Windmill
• Honeycomb Windmill
• Elliptical Windmill
• Sunflower Windmill
• Raccoon Windmill
• CLAMP for Windmills

Assembly:

Thanks to all followers and don't forget the virtual handshake 👍 ….Happy Printing

Commercial license you can get here:

https://www.patreon.com/BamBamDesign/membership