1 / 4
Growmau5 Far Red Initiator Puck 45° Wallmount — image 1
1 / 4

Growmau5 Far Red Initiator Puck 45° Wallmount

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

45° Wallmount for the Growmau5 Far Red Initiator Puck, probably best printed in PETG/ABS or similar higher temperature…

Rating
0 / 5
Likes
2
Downloads
10
Makes
0
Views
238
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

45° Wallmount for the Growmau5 Far Red Initiator Puck, probably best printed in PETG/ABS or similar higher temperature yielding plastic as the puck can get quite warm. I have retrofitted my pucks with extra passive heatsinks on the back attached with thermal adhesive. The mounting holes are approximately 2mm, I drilled those out a bit and tapped them to 3mm thread then mounted some spare computer standoffs. You will need a 5x2.5x5.5mm Male Right Angle DC Power Plug to power the puck, I was planning on having the power cable come out the top, but it was a bit of a brain twister drawing all those angles and it ended up the wrong way up. I put a notch through the top for a cable tie for strain relief.

Print Settings

Printer Brand:

Prusa

Printer:

i3 MK3

Rafts:

No

Supports:

No

Resolution:

0.1

Infill:

100


Filament:

3dfilaprint PETG Black

Notes:

Printed in black PETG at 0.1 100%infill, probably could've used 0.2 if I'd thought about it. I used a brim around the edge to keep it flat on the bed.

Category: Outdoor & Garden

Tags