1 / 1
Ender 3 V3 SE Lightbar
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Light bar that fits a 10mmx200mm section of led strip and fits where the spool holder was. Nuts and bolts included!
- Rating
- 5 / 5
- Likes
- 65
- Downloads
- 187
- Makes
- 1
- Views
- 3,405
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Public Domain
Soldered to the middle of the led strip, wrapped wires around arm, ran towards screen side, held down with tape and ran to the 24v on the board. Have since cut the wires and put on fully insulated spade connectors so I can disconnect the light when needed. In the future will order a 24v toggle switch and cut a hole into the printer frame to fit and run the wires up through the Z extrusion.