Nextbase 522GW Dashcam Click&Go PRO GPS Mount 3M Base
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€0.21 – €0.26 net (excluding VAT)
For file: nextbase v12_0.4n_0.2mm_PETG_MK4IS_12m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.24 excluding VAT (range midpoint).
- Weight reported by the author
- 4 g
- Print time reported by the author
- 12 min
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A base compatible with Nextbase's Click&Go system. Use with 3M VHB.
- Rating
- 5 / 5
- Likes
- 19
- Downloads
- 235
- Makes
- 1
- Views
- 1,060
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution
My Nextbase 522GW came with two adapters for attaching to the window, a suction cup and a flat plastic base for use with a small piece of 3M VHB. I had only used the suction cup for years and now that I want to permanently attach it with the 3M tape I couldn't find the backing plate anywhere. So, I sketched up a quick model in Fustion360 and after a few prototypes, came up with this, which seems to get the job done. I got rid of the “clicky bit” in the middle, you can just see a rectangular cutout in its place, because it was an absolute nightmare to print with or without supports if I used PETG, which is ideally what I wanted for its heat resistance. This seems to lock-in quite nicely though, even without this piece, so it will stay a cutout :)
In the hopes that someone else will find this model useful, I'm publishing it here along with the original fusion file, so feel free to make modifications to it however you see fit.
I recommend to use a layer height of .20mm (I had pretty bad stringing below that)
I've just used the default preset for PrusaSlicer: 0.20mm STRUCTURAL - Prusament PETG, printed on my mk4.