Qidi Q1 Pro bed plate stoppers aligners (short version of needitmakeit shroud - remix)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I wanted to have some stoppers (aligners) for the bedplate since original bed cover was ugly and didn't work too well.
- Rating
- 3 / 5
- Likes
- 23
- Downloads
- 130
- Makes
- 0
- Views
- 1,544
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution
You can use original screw holes in the bed platform to mount those. I used self tapping screws, after drilling screw holes to 2,5mm (in the printed part). You could also use hole compensation parameter in the slicer (Orcaslicer has it for sure) to adjust holes diameter.
Firstly, you have to unmount the original (ugly) bed cover. The process is very simple. There are only 4 screws. Process is well shown in the needitmakeit YouTube video. You can check the remixed model link for more details.
As for the assembly, screw the screws in almost all the way, then mount the bed plate to make final adjustments, and finally, screw all the way to ensure the parts stay in place.
Note: Remember about the ground wire on the right side of the bed plate.
Use some heat resistant filament. I used PA12+CF (probably overkill).
Infill is not too crucial (25% should be ok), but I used 5 walls in the print.