Laptop stands for cooling (no supports, printinplace)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
These are extendable laptop stands to improve its cooling during operation. (No supports) Suitable for 13-17'' laptops
- Rating
- 0 / 5
- Likes
- 13
- Downloads
- 114
- Makes
- 1
- Views
- 522
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution
No supports needed, it's print in place model.
To place the magnets you shoud pause the printing process in certain time or modify G-code adding a pause. If you don't have magnets, or you don't want to place them inside the stands, it's also OK to skip this step and print it without the magnets inside (I've tested it without magnets, it worked fine) or print the ‘no-magnets’ version: “Notebook_leg_NO_magnets_EasyCool.STL”.
There's also a version for cylindrical 3x3mm magnets to be inserted after print is finished. To fix the magnets you can use hot glue, superglue or other suitable one. And again, if you don't have magnets, or you don't want to place them inside the stands, it's also OK to skip this step and just use it without the magnets inside.
These stands are glued to the bottom of the computer using double-sided tape. It's also quite OK to use it without double-sided tape, just place it under your laptop.
_______________________________________________________________________________________________________________
Update 21.05.2024 - remixed one (double-legged, two levels laptopriser) here: https://www.printables.com/model/887831-laptop-double-legs-stands-no-supports
_______________________________________________________________________________________________________________
Update 21.05.2024 - repaired - I've made a better fillet to provide better openning.
- Also changed 3x3 mm cylindrical magnets to 4x3mm ones and placed them on the left and right sides, to be inserted after print is finished;
- And to prevent deformation of holes for 4x3mm cylindrical magnets placement (because of no-supports printing), I've added cylindrical insertions, which should be removed after printing (quite easy to remove).
- And I've also made an additional TPU-insertion (other plastics are also OK), but you can use the stands without these insertions.
________________________________________________________________________________________________________________