Blaston Trophy (from the VR game Blaston)

Hello,

I made this model for a VR Lan event in Italy as the prize for winning the Blaston VR tournament. (OMINIUM LAN)

As you can see from the picture I made this model as big as I could and therefore had to break it down into multiple parts.

The stl models are quite small but all are scalable (I think I scaled to 400% but don't remember) just ensure all scaled to the same size % from the orginal.

I used .18 for the base with 3 walls.

all other parts were .12 with 3 walls, I think I used 15% gyroid infill but this preference.

Print the Cup with top on the bed, no supports were necessary.

Pillar V2 will print but I found cutting it (pillar top/bottom) and gluing together made the whole thing much more stable)

The handles were printed flat on the bed and I used ironing for a nice surface finish.

The Plaque still has the logo from the evet on it but just cut it off or create a new plaque using your slicers built in object creation just make sure it'll fit into the recess on the base.

I found printing the plaque laid down with no top layers and 20% concentric infill gave an interesting and aesthetically pleasing finish to it  (use a modifier with top layers and 100% infill for whatever logo/text you decide to put on top to achieve the same effect that can be seen in the Pic).

I added the Cup.obj so you can see the full model but I don't recommend printing from this model. 

and don't forget to go slow for the outer walls if you're using silk filament for that shiny finish.

(Note: 'pillartopcut' was added as I broke the original and repaired it using pla gloop-might come in handy) 

Bonus: the coin is also the digital currency from the game I filled the cup with a load of these - cut the coin in half and glue together)

Happy printing :)