Supportberry - Strawberry support you've been looking for
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Strawberry plant support optimized for 3D printing.
- Rating
- 5 / 5
- Likes
- 25
- Downloads
- 106
- Makes
- 2
- Views
- 631
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial
A simple yet optimized for 3d printing model of strawberry supports.
Also available for printing in stacks.
PETG is suggested since it can withstand outdoor conditions way better than PLA.
Models:
Initial release
- Strawberry support split in half. Choice of two sizes
- (fits p1p/p1s/x1c/a1): 250mm (outer) x 80mm (inner) diameter
- (fits a1 mini): 170 (outer) x 50 (inner) diameter
- hexagonal spike legs 10cm long
Slim:
After using these in the garden, my wife discovered that 3mm supports are “more than enough” and 2mm are “good enough”, saving some plastic. Thus, a slim version appeared.
Printing guidelines:
- 4 wall loops for the horizontal part
Printing in stacks:
- Note: one side of each item won't be very nice, but you can orient it to face the ground
- Make sure ironing is enabled for all top surfaces for the horizontal part
- There's a tiny 0.2mm gap between parts in the stack to allow splitting
- Use a tiny flat screwdriver or a knife to start splitting them apart near the middle of the outer ring
More diameters will be available in the coming days.
Meanwhile, you can customize the model for free for your needs in onshape by following this link.
PS. Inspired by this model and the remix. Thanks, guys =)