1 / 5
Z-Axis Gantry Stabilizer for Ender3 V3 KE (and maybe SE) — image 1
1 / 5

Z-Axis Gantry Stabilizer for Ender3 V3 KE (and maybe SE)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A kit of parts to stabilize the gantry on the Ender3 V3 KE

Rating
0 / 5
Likes
19
Downloads
65
Makes
0
Views
2,380
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

My Ender3 V3 KE is a great little printer, but the gantry seems pretty wobbly at high speeds.

 

I couldn't resist the urge to fix that… so I came up with these parts.

 

You'll need to disassemble the base a bit and install two of the reinforcing inserts (I used 2-part epoxy).  You'll need to remove the controller board to install one of them.  Then drill some holes (with a 3.8 or 4mm drill bit) up through the bits (using the guide holes).  Then drill out and install M3 threaded inserts on the base of the printer (3 per side).

 

Then you can build some rods using ¼" steel rod (hardware store), the couplers, some two-part epoxy, some M5 screws, and some male tie rod end bearings (check eBay for those, like here: https://www.ebay.ca/itm/195553074485).  You'll need both right-tightening and left-tightening ones, as well as extra nuts to go along with them.  One left-turning and one right-turning per rod - that way, you can rotate the rods to tighten/loosen things.

 

I printed the parts in PETG.   I screwed the M5 screws for the bearings directly into the brackets.   Some M5 threaded inserts would have been nice, but it seems solid enough without them (just don't uninstall / reinstall them over and over, I guess).

 

Here's a version I did on my Wanhao Duplicator i3
https://www.printables.com/model/168060-wanhao-duplicator-i3-monoprice-mp-maker-select-z-a/collections#preview

 

And here's the original project for that:

https://reprap.org/forum/read.php?94,774348

https://letsprint3d.net/guide-install-z-brace-mod-kit-maker-select-v2/

Tags