1 / 8
Ikea FÖRHÖJA Acrylic Plate System (Toddler safety / dust barrier) — image 1
1 / 8

Ikea FÖRHÖJA Acrylic Plate System (Toddler safety / dust barrier)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Complete kit to make an Ikea Förhöja tea cart toddler save and keep dust out.

Rating
0 / 5
Likes
0
Downloads
9
Makes
0
Views
249
Reviews
0

Updated at source:

Model information

Category
Kitchen
License
Creative Commons — Attribution

I created this setup to make the Förhöja tea cart toddler sage. Our little boy has a great interest in all what is bottle shaped. To keep him from toying with the bottles, and later on to also secure the drawers from getting pulled out by accident, I created this system to allow easy access to the content of the cart.

 

Fix the plate rails with the M3x16 woodscrews to the bottom frame.

Insert the acrylic side plates into the rails and mark where the holes for the screw inserts need to be.

Mark the screw insert holes on the front/back panels. 

Use the 9mm wood drill to drill the holes for the wood screw inserts.

Add the screw inserts.

Take one M6x25 screw between the turn handle top and bottom part and glue them together. Push the turn handle through the top holes in the acrylic side panels and add the turn handle plate retetion piece over the screw. It can be glued the turn screw top part. Use one pair of the screw rings on the top holes of the front/back panel between the acrylic plate and the tea cart and add one between the acrylic plate and the lens head screws.

Additional elements needed for a full setup:

  • 4 Din 933 M6x25 screws with hex head
  • 12 wood anchor nuts M6x15
  • 40 M3x16 wood screws
  • 8 M6x16 lens head screws
  • Glue that works with PETG/PLA+
  • 2x acryl plates with 2mm thickness 296x650mm (holes according to the image)
  • 2x acryl plates with 3mm thickness 716x690mm (holes according to the image)
  • 9mm wood drill for the anchor nut inserts

For best stability, print the plate rails standing up, I used a 10mm brim to add additional holding strength on the build plate.

Print settings:

Material: PETG/PLA+
Layer Height: 0.2mm
Walls: 5
Infill: Grid, 25%

Tags