Simple Sliding Under Desk Trash Can

A simple trash can that goes under your desk, slides out, and holds a trash bag.

There are a few clever things happening here. 

First, it's designed to print with very very minimal supports - even the internal trash bag holder. 

See the 3MF (I recommend importing that 3MF into OrcaSlicer so you can use it). I've actually MODELED the supports into the model assembly itself, and then set them as an object that prints with 0 perimeters and minimal rectilinear infill. This “mimics” the creation of supports, because if you paint supports in, they won't work properly. They have been tested, and are easy to remove. 

The second “clever” thing is of course the internal trash bag holder, which, I'm very proud to say, is designed to print WITHOUT their own supports!

HOWEVER, there is one thing I didn't do in a clever way, and that's the fact that there is no rear stopper for the trash can. 

I was too lazy / busy to model it, and instead opted to just place some extra screws behind the bin to prevent it from being pushed back. I encourage someone to remix the brackets if you want to fix that problem. I might get around to it later, and reprint… because I'll admit that this is annoying.

You can download STEP files, or copy this model and make it your own here! https://cad.onshape.com/documents/7695460fc84f6dd551d2e5bf/w/4285199e817520d002334394/e/458e741edc7b468c6426f087 

You can print in PLA, PETG, ABS, anything really. Just make sure to have a LOT of perimeters around the top. I printed it solid. 

ENJOY!
JL